Natural stone holds up well in a home near the beach when it is set and sealed as one system, from the membrane underneath to the sealer on top. Most of the attention goes on the stone you can see. The layers you cannot see decide how it looks in ten years.

What the sea does to stone

Salt is the main problem. Limestone, travertine and marble all have fine pores, and on a beachfront site the air carries salt and moisture into them. When the water dries, the salt stays behind and forms crystals inside the stone, and over time that pressure can mark or flake the surface. Wind off the water makes it worse, because it pushes moisture into joints and edges that would stay dry on a street further inland.

Water also comes from behind. Moisture that gets under a tile through a joint or a crack has nowhere to go, so it moves through the stone and leaves stains on the way out. That is why the work under the stone matters as much as the choice of stone.

Why stone is laid as a system

A stone floor or wall outdoors has four jobs to do at once. The membrane keeps water out of the structure, the glue holds the stone to it, the grout closes the joints and the sealer slows down what gets into the surface. If those products come from different makers and were never tested together, one of them can undo another.

At a’Maré, our three residences above Elouera Beach, the membrane, glue, grout and sealer were chosen as one set for natural stone in those conditions.

If a builder tells you the stone is “fully waterproofed”, ask what membrane went under it and whether the glue and the sealer are approved to work with it.

Which stone goes where

Stone has to suit its job as well as its site. A benchtop takes hot pans and spills. A bathroom floor takes water and bare feet, and a terrace takes sun, salt and everything the weather brings.

At a’Maré the kitchens have Taj Mahal stone benchtops, and the outdoor entertaining areas carry the same stone around the barbeque station. The bathrooms are finished in Super White travertine on the floors and walls, and the penthouse has Bianca Crema Italian marble floors. The heated spa on the balcony is finished in Ezarri Spanish mosaics, which is a tile made for life under water and a good reminder that the right material is sometimes not stone at all.

Our note on private pools and spas on apartment terraces goes further into that part of the job.

Stone care at home

Stone needs some care, though less than people fear. Marble, travertine and limestone react to acid, so lemon juice, vinegar and the wrong bathroom cleaner can leave a dull mark on the surface within minutes. Wipe spills early and use a cleaner made for natural stone. A honed finish hides those marks better than a polished one, which is worth thinking about in a kitchen you plan to cook in.

A sealer wears over time, and faster on a terrace in full sun. Ask for the product name and the maker’s care instructions when you take the keys, and keep them with your home’s paperwork. Rinsing salt off outdoor stone with fresh water is simple work and worth doing often when you live this close to the beach.

Questions to ask before you buy

If stone matters to you, ask to see it in a finished home, in daylight, from up close. Ask what each stone is called and how it was sealed. Check the joints around a shower and at the edge of a terrace, because those are the first places a shortcut shows. Then ask what happens if a piece cracks, and whether the same batch is on hand for a repair.

The site can tell you a lot too. A home a few hundred metres from the water faces a gentler life than one looking straight onto it, and we cover the rest of what the coast asks of a building in our note on building near the water in the Sutherland Shire.