Start with the NSW Planning Portal’s Spatial Viewer, which shows the zoning of any lot in the Sutherland Shire on a map. For an answer you can rely on, order a planning certificate from Sutherland Shire Council, which states the zoning and the planning controls that apply to the land.
The Spatial Viewer
The Spatial Viewer is the NSW Government’s online map of planning controls. Search your address and it shows the planning maps that cover your lot, and you can download a property report for it. The Planning Portal also publishes open data layers for zoning, height of buildings, floor space ratio and lot size.
Those layers answer the first questions about a site in a few minutes. Height of buildings is shown in metres. Floor space ratio compares the floor area of a building with the area of its site, so a ratio of 0.5:1 on a 600 square metre lot allows 300 square metres of floor area. The maps are a starting point, though, and the certificate is the document that settles them.
The planning certificate
A planning certificate is issued by the local council under section 10.7 of the Environmental Planning and Assessment Act 1979, and Service NSW notes that it is also called a zoning certificate. It comes in two forms:
- A section 10.7(2) certificate shows the zoning and the State, regional and local planning controls that apply. It also shows constraints such as contamination, flooding and bushfire prone land.
- A section 10.7(2) and (5) certificate adds advice from other authorities and other information the council holds about the land.
You can apply through the NSW Planning Portal, which charges its own service fees, or apply directly with council. Anyone buying, selling or planning work on a lot should read the full certificate, because the constraints section can matter as much as the zone.
What the zone tells you
In the Shire, the zoning comes from the Sutherland Shire Local Environmental Plan 2015. Each zone in the plan has a land use table, which lists what can be built with consent and what is prohibited. The plan also sets development standards on its maps, such as the height of buildings, the floor space ratio and the minimum lot size.
Residential zones use standard names across NSW, such as R2 Low Density Residential, R3 Medium Density Residential and R4 High Density Residential. The letter and number on your lot tell you which table to read.
The policies on top of the plan
The Local Environmental Plan is not the only layer. State policies can permit housing the zone alone would not. Near nominated stations and town centres in the Shire, such as Caringbah, Cronulla and Kirrawee, the Low and Mid-Rise Housing Policy permits more housing types with its own standards. Our note on low and mid-rise housing in the Sutherland Shire explains which areas it covers and what it allows.
Hazards cut the other way. The same policy does not apply to some land affected by bushfire, flooding or heritage, so the constraints on your certificate decide whether a lot is in or out.
When the zoning does not fit your plans
If the zone does not allow what you have in mind, there are a few ways forward:
- Vary a standard. A development application can ask to vary a development standard, such as height, where a full change to the plan is not needed.
- Change the plan. A planning proposal asks to amend the Local Environmental Plan itself, and suits changes to zoning or permitted uses.
- Join with your neighbours. A lot that is too small on its own can work as part of a larger site, set out in our note on site amalgamation in the Sutherland Shire.
From zoning to a decision
Zoning tells you what is allowed on a lot. It does not tell you what is worth building, and that takes a feasibility study, which sets the cost of building against what the finished homes would be worth.
We are based in the Shire, with our office in Caringbah, and our planning work covers feasibility studies, planning proposals, development applications, and HDA and SSDA proposals. If you have looked up your zoning and want to know what it means for your land, talk to us.
