It means more kinds of housing can now go on residential land near ten stations and town centres in the Shire. The list runs from dual occupancies and terraces to apartment buildings. The NSW Low and Mid-Rise Housing Policy is part of the State Environmental Planning Policy (Housing) 2021. It applies to residential zones within 800 metres walking distance of nominated town centres and stations, makes these housing types permissible with consent, and sets standards that a council cannot use to refuse a project that meets them.
The Shire’s nominated centres
The NSW Government has nominated ten centres and stations in the Sutherland Shire:
- Caringbah station and town centre
- Cronulla station and town centre
- Engadine town centre
- Gymea station
- Kirrawee station and town centre
- Menai Marketplace shopping centre
- Miranda station and town centre
- Southgate shopping centre
- Sutherland station and town centre
- Woolooware station
The 800 metres is a walking distance, not a straight line, and it runs from the town centre or from the entrance of the station. The Department publishes indicative maps of each area.
What can be built
Within these areas, the policy sets non-discretionary standards for each housing type. These are the main ones:
- Dual occupancies. Permitted with consent in R2 zones across NSW. Minimum lot of 450 square metres and 12 metres wide, floor space ratio up to 0.65:1, height up to 9.5 metres.
- Townhouses. Multi-dwelling housing is permitted with consent in R2 zones within these areas. Minimum lot of 600 square metres and 12 metres wide, floor space ratio up to 0.7:1, height up to 9.5 metres.
- Terraces. Permitted with consent in R2 zones within these areas. Minimum lot of 500 square metres and 18 metres wide, floor space ratio up to 0.7:1, height up to 9.5 metres.
- Apartment buildings in R1 and R2 zones. Residential flat buildings are permitted with consent in R2 and R3 zones within these areas. In R1 and R2, the minimum lot is 500 square metres and 12 metres wide. The floor space ratio can go up to 0.8:1 and the height up to 9.5 metres.
- Apartment buildings in R3 and R4 zones. Within 400 metres of the station or centre, up to 6 storeys, 22 metres and a floor space ratio of 2.2:1. From 400 to 800 metres, up to 4 storeys, 17.5 metres and 1.5:1. No minimum lot size or width applies.
What non-discretionary means
These standards are also called non-refusal standards. They prevail over any more onerous standard on the same matter in the council’s Local Environmental Plan or development control plan. If a proposal complies with one of them, the consent authority cannot refuse it on the grounds that it does not comply with that standard. The project still needs development consent, and it is still assessed on everything else.
Where the policy does not apply
The policy does not apply to land affected by certain hazards and constraints. The exclusions in the Housing SEPP include these:
- Bushfire-prone land, including the buffer zone.
- Some flood-prone land.
- Land that is or contains a heritage item.
- Land under high aircraft noise.
- Land in a Transport Oriented Development area.
Bushfire-prone land shows on a planning certificate and on the NSW Planning Portal Spatial Viewer. An indicative map is a starting point, and the planning certificate and the legislation decide whether a particular lot is in or out.
What it means for a landowner
For a landowner near one of these centres, the policy changes what the land can hold, and the first job is to find out by how much. Work through it in order:
- Confirm the lot sits inside an area and outside the exclusions, using the planning certificate.
- Check the zone, because the standards for R2 land differ from those for R3.
- Test the yield and the numbers in a feasibility study.
- Decide who carries the development. Some owners sell, and others keep the land in the deal through a development joint venture.
If the site needs more than the policy gives, the next step up is a planning proposal. We are based in the Shire, with our office in Caringbah.
