Noise between apartments in NSW is controlled at two levels. The National Construction Code sets minimum sound ratings for the walls and floors between homes, and the NSW Apartment Design Guide asks the architect to plan the building so that noisy and quiet spaces sit apart.

The ratings in the code

Part F7 of the National Construction Code, Volume One, deals with sound transmission and insulation in Class 2 and Class 3 buildings. Its deemed-to-satisfy provisions set these minimums:

  • Floors between homes. Rw + Ctr of at least 50 for airborne sound, and Ln,w of no more than 62 for impact sound.
  • Walls between homes. Rw + Ctr of at least 50.
  • Walls to a lift shaft, plant room, stairway or public corridor. Rw of at least 50.
  • A front door off a public corridor. Rw of at least 30.

Floors between a home and a plant room, lift shaft, stairway, public corridor or lobby carry the same floor ratings.

What the numbers mean

Rw measures how well a wall or floor stops airborne sound, such as voices or a television. A higher number is better. Ctr adjusts that result for low-frequency sound, such as bass from a speaker or traffic outside, which is harder to stop. Ln,w measures impact sound, the thud of footsteps or a dropped pan travelling down through a floor, and with this one a lower number is better.

So a floor has to pass two tests. It has to hold back the conversation above, and it has to soften the footsteps.

Bathrooms, kitchens and pipes

The code adds rules for the noise that plumbing makes. If a bathroom, laundry or kitchen in one home sits against a habitable room in the next, the wall between them must also be of discontinuous construction. That means two separate leaves with a cavity of at least 20 mm between them, so sound has no solid path across.

Pipes that serve more than one home need their own separation. Where they pass a habitable room, the construction around them must reach Rw + Ctr of at least 40, or 25 where they sit next to a kitchen or a non-habitable room.

Planning the building around noise

The Apartment Design Guide works on the plan before any wall is built. Its guidance on acoustic privacy includes these points:

  • Noisy areas such as building entries and corridors sit next to or above each other, and quiet areas sit next to or above quiet ones.
  • The number of party walls, the walls shared with other apartments, is kept low, and those walls are insulated.
  • Garage doors, driveways, plant rooms, mechanical equipment and circulation areas sit at least 3 metres from bedrooms.
  • Inside each home, rooms with similar noise needs are grouped together, doors separate the zones, and bedroom wardrobes are placed to act as sound buffers.

Where that separation cannot be achieved, the guide points to double or acoustic glazing, acoustic seals and materials that resist noise.

Hard floors

Stone and timber floors wear well, and they pass a footstep into the slab more readily than carpet does. The finish you see is only the top of a build-up, and what sits between the finished floor and the concrete decides how much of that sound reaches the home below. In a building with hard floors throughout, it is the first detail to ask about.

Full floor homes

A full floor plan takes away the shared wall on your own level. At a’Maré in Cronulla, each of the three residences occupies the entire floor, so no two homes share a living wall. The shared surfaces are the floors and ceilings between levels, in a concrete frame poured floor by floor. Our note on full floor apartments covers how that plan works.

Questions to ask

Sound is hard to judge on an inspection of an empty home, so ask:

  • What ratings were the walls and floors designed to, and was the work checked against them?
  • Where are the lift, the plant and the garage door in relation to the bedrooms?
  • What sits under the hard floors?
  • Which walls, if any, does the home share with another apartment?

Our note on Class 2 buildings explains the wider rules these apartments are built to. If you want to talk through a home of ours, talk to us.